Welding machines work hard in hot, dusty and humid conditions. A few regular checks keep them reliable and help you spot problems before a machine breaks down in the middle of a job.
Weekly checks
- Keep it clean: grinding dust inside an inverter can cause short circuits. With the power off and unplugged, blow out dust with dry compressed air, following the maker’s instructions.
- Check airflow: make sure the fan runs and the vents are not blocked.
- Inspect cables: look for cracked insulation, loose connectors and hot spots on welding and power cables.
- Check connections: keep the electrode holder, earth clamp and panel connectors tight and clean.
MIG and TIG extras
- Check MIG drive rolls for wear and the liner for dirt. See our MIG consumables guide.
- Check gas hoses and connections for leaks.
- Replace worn TIG torch parts. See our TIG torch parts guide.
Warning signs of a fault
- The machine trips, overheats or shuts down more often than usual.
- The arc is unstable even with good consumables and connections.
- The current setting does not match the actual output.
- Burning smells, unusual noises or visible damage.
If you see any of these, stop using the machine and have it checked. Do not open an inverter while it is connected: capacitors can hold a dangerous charge.
Repair and calibration
Fong Yung Industries LLP offers in-house welding machine repair and calibration, as well as hydraulic, pneumatic and magnetic machine repair. Repairing a machine is often much cheaper than replacing it.
Need a new machine?
If a machine is beyond repair, we supply MMA, MIG and TIG welding machines in the EVO-Weld range. request a quote or contact us to book a repair.